Monday, April 25, 2022

With a little planning, you can maximize your specialty paper using the zero-waste die cutting technique

 What is zero-waste die cutting?

With zero-waste die cutting you use all of the pieces from your die cuts, even the negative space and the "innies." It requires a little planning ahead because you need to think about how you will use both your initial die cut as well as the leftovers.

In this short video I show you a couple tricks I have learned along the way to make this technique a little easier, especially when using intricate dies.


Here are some more examples.


I used the left-overs from this beautiful blue holographic paper

To make this card.  I like this one better!

Is it a red poinsettia, or a poinsettia on red?  Notice how I switched up the greetings.



I used some leaf skeleton dies to cut these leaves from a master board and some green and brown cardstock.  I alternated the innies from each as inlays. I love how they turned out!


After cutting the leaves out, I didn't want to toss what was left of my master board, so I backed it with yellow cardstock and used some of the die cuts to stencil in the leaves with green chalk.


I hope this has inspired you to look at your die cuts in a different light!






Saturday, April 23, 2022

Four Easy Steps to Make a Master Board

 What is a master board?

There are a lot of different ways to make a master board, but basically a master board is a mixed media collage that is made on a large background that is then cut down and used in smaller projects. Creating a master board is fun and can be as simple or as difficult as you want it to be. There are no rules.

Steps to make a master board

Here are the steps I took to make a master board from patterned paper scraps:

1. Cover a sheet of paper with patterned scraps

This is possibly the most time-consuming step. I used scraps that I would normally discard so some of them are quite small. This step took well over an hour.

First layer of master board covered in patterned scraps

I like to completely cover the paper. This results in many areas having multiple layers. Since the finished product is going to be cut apart, it is important to make sure that each layer is completely glued down. I've used Aleene's Tacky Glue* as well as Golden Matte Gel Medium.  I recommend wearing gloves for either one to avoid sticky fingers!

2. Stamp some interesting images or shapes

Dig through your stash for some stamps with interesting shapes or images. I have a set of flourishes and filigrees that I rarely use. I thought it would be perfect for this project. I stamped them with Memento Tuxedo Black ink*, but you could use colors as well.

Master Board with stamped images

3. Stencils and Acrylics

Next comes the messy part.  Grab some sponges, stencils and acrylic paint in multiple colors (I used purple, yellow and hot pink). Stencil several areas with different colors.  

Stenciling with acrylic paint

I only used one stencil this time (by Balzer Designs), but I often use two or three. 

4. Heat Embossing

Wait until your project is completely dry to do this step.  While you are waiting for it to dry, collect the following:

I recommend only stamping a few images at a time, and then embossing them. It's easier to keep track of where you have stamped that way.

Completed master board with stamping, stenciling and embossing

Once you've finished the embossing, you are done.

That was easy, wasn't it?

What can you do with a master board?

Here are just a few ideas.

  • They make great tags


  • Die cut leaves or other shapes




  • Use it for a card front
  • Make a journal cover
  • Make a wall-hanging.